PowerMode - Standby Mode

Introduction

In this example, the development board will demo the Standby Mode for power save. There are 6 wake-up sources. The system will count down 5s then go to power mode Standby. After the wake-up source being processed, the system will reboot.

Procedure

Open face detection example in “File” -> “Examples” -> “AmebaPowerMode” -> “StandbyMode”.

Next is setting up the system and entering the power mode. Please refer to the following steps for entering Standby mode.
Step 1. Set up the “WAKEUP_SOURCE”, AON timer: 0; AON GPIO: 1; RTC: 2, PON GPIO: 3, UART/Serial1: 4, Gtimer0: 5.
Step 2. Set up the wake-up source setting. There are 6 wake-up sources, each one has its own settings.
For AON timer, at section ”#if (WAKEUP_SOURCE == 0)”, set value to “CLOCK” and “SLEEP_DURATION”. “CLOCK” can be 4MHz or 100kHz. “SLEEP_DURATION” unit is in seconds.
For AON GPIO, at section “#elif (WAKEUP_SOURCE == 1)”, set value to “WAKUPE_SETTING”. “WAKUPE_SETTING” in this case is the Pin number, that can be 21 or 22. The GPIO pin is set to active high, please refer to the following connection.

For RTC, at section “#elif (WAKEUP_SOURCE == 2)”, set value to “ALARM_DAY”, “ALARM_HOUR”, “ALARM_MIN”, or “ALARM_SEC”. All alarm values set the duration of RTC wake-up. The range is “1day, 0h, 0m, 0s” to “365day, 23h, 59min, 59s”.
For PON GPIO, at section “#elif (WAKEUP_SOURCE == 3)”, set value to “WAKUPE_SETTING”. “WAKUPE_SETTING” in this case is the Pin number, that can be 0 to 11. The GPIO pin is set to active high, please refer to the following connection.

For UART/Serial1, there is no setting required. However, USB to ttl serial cable Tx(green) and Rx(white) pin needs to connect to Serial1 Rx and Tx pin. Refer to the following connection. (Power 5V/3.3V Red, Ground Black)

For Gtimer0, at section “#elif (WAKEUP_SOURCE == 5)”, set value to “SLEEP_DURATION”. “SLEEP_DURATION” is the timer sleep duration in seconds.
Step 3. Start the Standby mode. There is only 1 optional setting for this step. When the wake-up source is set to RTC, use “PowerMode.start(1970, 1, 1, 0, 0, 0);” to replace “PowerMode.start();” for setting the start time. (Default is 1970.1.1 00:00:00).

To wake up, all timers will automatically wake up when the duration is finished, all GPIO pins must active high by pressing the push button, UART needs to give input by Serial1 though USB-ttl cable.
The correct boot, enter Standby, and reboot cycle will be same as following picture.