Ameba Arduino: [RTL8195AM] [RTL8710AF] Flash Memory -Store data in Flash EEPROM


Preparation

  • Ameba x 1

Example

Ameba provides Flash Memory component for data storage and the data can be preserved when the power is off if necessary, e.g., compiled program. To avoid the memory space overlapped with the program on Ameba, the Flash API uses the tail part of the address space, with sector size 4K.

In this example, we store the value of boot times in flash memory. Every time Ameba reboots, it reads the boot times from flash, increases the value by 1, and writes it back to flash memory.

First open the example, “File” -> “Examples” -> “AmebaFlashMemory” -> “FlashMemoryBasic”
1

Compile and upload to Ameba, then press the reset button.
Open the Serial Monitor, press the reset button for a few times. Then you can see the boot times value increases.
2

Code Reference

By default, the Flash Memory API uses address 0xFF000~0xFFFFF to store data. There is limitation when writing to flash memory. That is, you can not directly write data to the same address you used in last write. To do that correctly, you need erase the sector first. The Flash API of Ameba uses a 4K SRAM to record the user modification, and do the erase/write task together.

Use FlashMemory.read() to read from Flash memory.
Use FlashMemory.buf[0] = 0x00; to manipulate the 4K buf.
Use FlashMemory.update(); to update the data in buf to Flash Memory.

Copyrights ©瑞晟微电子(苏州)有限公司 2021. All rights reserved.
Please confirm that QQ communication software is installed